Maxtor Built in Digital Video Recorder Instrukcja Użytkownika Pobierz pdf (Strona 32)

DVR200 Series User’s Manual

Detected Area Setup

After selected this item, the detected area is displayed as follows. The

detection area consists of 192 (16×12) detection grids.

Use the Direction keys to move the cursor and press ENTER to select or

de-select a grid. Press MODE to select all of the grids for detection; press

MODE again to de-select all of the grids.

Sensitivity

This item is used to set the sensitivity of detection grids for the camera. A

greater value indicates more sensitive motion detection. A motion alarm will

be triggered once the amount of motion detected exceeds the Threshold

value.

Move the cursor to <Sensitivity> and press ENTER, and then use UP/ DOWN

keys to adjust the value. The value is increased by 4% increment.

Block Threshold

<Block Threshold> indicates the motion alarm triggered level; select from

<1> to <16>. Selecting <1> means the DVR will trigger the alarm when one

grid is detected; and selecting <16> means the DVR will trigger the alarm

when 16 grids are detected. Move the cursor to <Block Threshold> and press

ENTER, and then use UP / DOWN keys to adjust the value.

3.6.8.5 Alarm In

This item allows users to enable/ disable alarm input detection. According to

users’ application, select <N/O> (Normal Open) or <N/C> (Normal Close) to

enable the alarm input detection, or select <OFF> to disable the detection.

If <N/C> is selected without installing any device, an alarm will be triggered

and the Event Icon will always display on the monitor until the selection is

changed to <N/O> or <OFF>, or when a device is installed.

1 2 ... 27 28 29 30 31 32 33 34 35 36 37 ... 72 73

Brak uwag

Maxtor Built in Digital Video Recorder Instrukcja Użytkownika Strona 32